Enclosure assembly guide
Outline
Foam rubber adhesive Instructions
Stand instructions
QA Check Instructions
Accessories Instructions
1. Stand
Secure four felt pads in each corner.
Attach the neck to the base.
-
Use [4] of the Black-Oxide Stainless Steel Phillips Flat Head Screws, 1/4"-20 Thread, 1/2" Long, Undercut screws.
Screw the Heckler pivot table to the base.
-
Using the screw pieces that come with the pack.
Place the hinge so that the split side is facing up.
-
Use [4] of the Alloy Steel Tamper-Resistant Button Head Torx Screws 8-32 Thread, 1/4" Long screws for the entire hinge.
Mount the universal holder to the neck via the hinge.
-
Use [4] of the Alloy Steel Tamper-Resistant Button Head Torx Screws 8-32 Thread, 3/8" Long screws.
Lastly, screw the universal claw to the neck via the hinge.
-
Use [2] of the Alloy Steel Tamper-Resistant Button Head Torx Screws 8-32 Thread, 1/4" Long screws.
2. Foam Rubber Adhesive
To prevent your iPad from getting scratched or sliding during use, cut out shapes from your foam rubber sheet and adhere them in the following order. Note that the adhesive is strong and will not move once put in place.
Part #2, Side
-
Fits entirely.
-
Thin, long strips (x2).
Part #3, Top
-
Fits entirely.
-
Rectangular shape (x1).
Part #3, Front
-
Place on top of Part #3 Top.
-
Be sure foam rubber adhesive isn’t placed too high above the metal enclosure.
-
Small, thin rectangular shape (x2).
Part #2, Bottom
-
Fits entirely.
-
Rectangular shape (x2).
Part #2, Front
-
Fits entirely.
-
Small, thin, rectangular shape (x2).
Lastly, screw the universal claw to the neck via the hinge
-
Use [2] of the Alloy Steel Tamper-Resistant Button Head Torx Screws 8-32 Thread, 1/4" Long screws.
3. Stand
Each kiosk set up needs a zip lock bag with the following items:
-
Pivot table attachments.
-
Pivot table L-key.
-
T15 L-key.
4. QA Check
To prevent your iPad from getting scratched or sliding during use, cut out shapes from your foam rubber sheet and adhere them in the following order. Note that the adhesive is strong and will not move once put in place.
Check physical stand
-
Flip stand over to check the bottom for felt feet and pivot table.
-
Be sure there are no marks/dents/scratches on the metal enclosure.
-
Be sure all of the foam rubber adhesive is in place.
Check for balance/wobble
-
If the neck or claws are wobbling, then tighten the screws again.
-
If iPad is wobbling or loose within the claw, push straight down on Part #3 Top and tighten the screws in place again.
Check power supply
-
After setting up all power management, plug into the outlet to be sure the reader and iPad are charging.
-
Be sure that your iPad battery percentage is above 50%.
Still need help?
Visit our FAQ page for more information.
Send us an email at help@chexology.com if you need support.